9 most frequently asked questions in electronics

Yes. Knowing the specific machine the error code applies to allows us to quickly search for the error code in the right service manual, pinpoint the exact problem and advise you on which steps to take.
In some cases, we can even determine the root cause of the problem. After all, the error code can just be a symptom of the error instead of the error itself. By digging a bit deeper, we can help you eliminate this problem.

Our database has electrical diagrams for an extensive range of machines. So, in most cases, we will have this information available and are happy to share it.
In some cases, you will need the hydraulic diagram as well. If available, you can make use of this particular diagram.

There can be a number of reasons why your machine isn’t working, despite fitting a brand-new part. Electrical and electronic parts like joysticks or control units often need to be calibrated before their first use. Get in touch, and we’ll guide you step by step through the calibration process.

UDS100 is a diagnostic software tool developed by UMS to help you with Linde, Jungheinrich and Still machines. It helps you perform diagnostics, set parameters, read error codes and perform calibrations. You can contact us to assist with the activation of the software, as well as a renewal of your license or the expansion of your package.

Setting up the parameters – for instance, of a joystick or an accelerator – essentially means determining the zero point and maximum point. TVH can help you set the right parameters for your part within the necessary safety tolerances. Keep in mind that we only offer advice based on the information we have been provided. The final checks and responsibilities always remain with the customer.

Usually, you need a dedicated diagnostics device specific to your machine’s make and model in order to read error codes, set up parameters or perform calibrations. These handheld devices aren’t universally compatible with every machine.

Don’t worry, we can help. Generally, you will need a device compatible with your machine's make and model. If necessary, we can offer short-term rental for diagnostics devices (only OEM) to help you out temporarily.

Your machine is built to last. It can be used for years or even decades. This also means it’s quite possible that some parts present in your machine have since been updated to the next generation. For instance, your new part's wire colour coding differs from the old one.

We’re happy to help. Send a picture or a video of your situation, and we will help you install the new part in your machine in no time.

You might have expected your control unit or PCB to be plug-and-play. Plug-and-play parts have all the right calibrations or parameters preset; you just need to connect the part to your machine.

Unfortunately, this is less often the case than you might hope, and you find yourself with a part that still needs calibration or parameters set up, or worse, a part with different firmware.

We want to be as clear as possible in our communication with you. So, if a part is plug-and-play, we will mention it explicitly in your quotation. If no mention is made, you can always contact us and we’ll resolve any doubts about whether your part is plug-and-play and to what extent.

Questions? In need of help? We have all the necessary tools and knowledge to help you with all your questions and problems. Don’t hesitate to reach out to your sales advisor, they will quickly tackle your issue. We keep you going!