Maintaining your equipment parts frequently and thoroughly means your equipment is operating in optimal condition for as long as possible. With 2021 right around the corner, there is no better way to start the new year than ensuring your equipment is in tip top shape.
Fluids
The parts of your equipment that allow you to operate safely and efficiently are dependent on proper fluid and oil levels. First, make sure your braking system is supported by sufficient brake fluid levels so you can make the stops and turns you need. Second, your equipment will not operate without the correct amount of hydraulic fluid. Hydraulic fluid is crucial for lubrication, energy transmission, and the transfer of heat for steering and mast controls. Finally, get the most out of your engine by checking your engine oil levels. Engines can experience faster wear and tear if the engine oil is not at the level it should be as engine oil is critical in not allowing the engine to heat up rapidly.
Battery
While you are under the hood checking your fluid levels, this is also a good time to check your forklift battery. Make sure there is no corrosion near the terminals, no loose cables or defects, and inspect the water level. By doing a check on your battery, you can extend the life of your battery and get the most out of your purchase.
Filter
The frequency that you need to check your filter likely depends on the environment where you are running your equipment. If you work in a space that is especially dusty, it may be necessary to clean the filter daily to ensure your engine is running as efficiently as possible. A general rule of thumb is to change your air and oil filters at the same time, typically every 500 hours. Hydraulic filters should typically be changed every 2000 hours but depends, in part, on the type of application you are running. Check your service manual for equipment specific recommendations about when to check and change your filters.
Tires
Keep your equipment moving efficiently by inspecting the tread on your tires. Pneumatic tires need to be replaced if you notice worn down tread or bald spots on the tire. Solid tires should be examined in accordance to the original size of the tire when you first made your purchase. If the size of the tire has shrunk or the tread is worn down, it may be time to replace your solid tires.
In addition to examining these important parts of your equipment, verify that your decals are readable, your forks are the right thickness, and look and listen for general malfunctions throughout your equipment. Follow these forklift maintenance tips and start your new year off with the most efficient and safe equipment. TVH has your replacement part needs covered, visit www.irmn.com or become a customer today to get the parts you need!