General Electric-controller
In these training courses, we focus both on forklifts and mobile elevating work platforms. The training courses marked with the IPAF logo are IPAF-approved. CAP points can be obtained for all IPAF-accredited courses. For each training day, you will receive 0.5 CAP point when you pass the theoretical test.
TARGET GROUP
Engineers who perform repairs on electric lift trucks equipped with General Electric controllers.
PRIOR KNOWLEDGE
Basic knowledge of the systems used in an electric lift truck.
GOAL
- Understanding the different technologies that have been used over the years in the GE product range.
- Understanding the operating principle of common controllers.
- To be able to correctly identify the specific card types or controllers.
- To be able to set parameters and perform calibrations.
- To be able to correctly set a new controller as a replacement for a faulty controller.
CONTENT
- To be able to make a distinction between the different series of GE controllers (EV-1, EV-10, EV-100LX, EV-100ZX, EVT-100ZX & SX-series).
- Identifying cards, setting up test bench connections and learning to work with the handset by modifying parameters.
- To be able to analyse faults and abnormalities on different GE controllers in order to make a correct diagnosis.
- To be able to make test configurations operate by taking measurement and solving faults.
- Becoming familiar with the use of the LX-handset and being able to modify parameters.
- Learning to use a Handy-man to measure and check components.
- Correctly interpreting error codes from the troubleshooting guide.
DURATION
1 day
TO BRING
- Working clothes
- Safety shoes
- Multimeter
CERTIFICATE
A certificate is issued once the training has been completed.
PRACTICAL INFO
This course has not been planned in at the moment. Please contact us should you be interested.
email: [email protected]
T +32 56 43 44 38