GENERAL ELECTRIC controller

General Electric (GE) offer a range of controllers that are used in electric lift trucks. ‘General Electric controllers’ is a 1-day training course that provides valuable insight for engineers who repair electric lift trucks equipped with GE controllers. You’ll learn about the different technologies used in the GE controllers range, and how to distinguish between the different series of GE controllers including EV-1, EV-10, EV-100LX, EV-100ZX, EVT-100ZX & the SX series. At the end of the day, you’ll not only understand the operating principles of GE controllers, but you’ll also be able to correctly identify specific card types and controllers, set parameters and perform calibrations, and install replacement controllers correctly. You’ll gain skills that make troubleshooting and fault-finding easier than ever, enabling you take measurements, solve faults and make repairs with improved efficiency.

TARGET GROUP

Engineers who perform repairs on electric lift trucks equipped with General Electric controllers.

PRIOR KNOWLEDGE

Basic knowledge of the systems used in an electric lift truck.

GOAL

  • Understanding the different technologies that have been used over the years in the GE product range.
  • Understanding the operating principle of common controllers.
  • To be able to correctly identify the specific card types or controllers.
  • To be able to set parameters and perform calibrations.
  • To be able to correctly set a new controller as a replacement for a faulty controller.

CONTENT

  • To be able to make a distinction between the different series of GE controllers (EV-1, EV-10, EV-100LX, EV-100ZX, EVT-100ZX & SX-series).
  • Identifying cards, setting up test bench connections and learning to work with the handset by modifying parameters.
  • To be able to analyse faults and abnormalities on different GE controllers in order to make a correct diagnosis.
  • To be able to make test configurations operate by taking measurement and solving faults.
  • Becoming familiar with the use of the LX-handset and being able to modify parameters.
  • Learning to use a Handy-man to measure and check components.
  • Correctly interpreting error codes from the troubleshooting guide.

DURATION

1 day

TO BRING

  • Working clothes
  • Safety shoes
  • Multimeter

CERTIFICATE

A certificate is issued once the training has been completed.

Enrol in a how-to session or technical training class

T +32 56 43 44 38 • [email protected]