![IPAF approved training course](/sites/tvh/files/inline-images/Ipaf.org%20logo_3.png)
In these training courses, we focus both on forklifts and mobile elevating work platforms. The training courses marked with the IPAF logo are IPAF-approved. CAP points can be obtained for all IPAF-accredited courses. For each training day, you will receive 0.5 CAP point when you pass the theoretical test.
TARGET GROUP
Engineers working with electricity and electronics, who want to improve their fault-finding skills.
PRIOR KNOWLEDGE
Some prior knowledge in performing electrical measurements and fault-finding is required.
GOAL
This hands-on training course familiarises the engineer with common sensor and actuator signals, gives a clear insight into the operating principle of processing units and teaches the engineer how to look for faults in a targeted way.
CONTENT
- Electrical diagram
- Properties of the electric circuit
- Basic principles
- Current and resistors
- Magnetism and electric interference
- How and when to use an oscilloscope
- Analogue versus digital signals
- Details of an oscillogram
- Pulse with modulation, duty cycle, frequency ...
- Proportional control
- Temperature sensor, pressure sensor, position sensor and speed sensor
- Communication signals (e.g. CAN bus)
DURATION
3 days
TO BRING
- Working clothes
- Safety shoes
- Multimeter / oscilloscope (if available)
- Test lamp
CERTIFICATE
A certificate is issued once the training has been completed.
PRACTICAL INFO
This course has not been planned in at the moment. Please contact us should you be interested.
email: [email protected]
+32 56 43 44 38
Check our calendar of planned courses